ZiPFactory is proud to announce the introduction of the ZiP™ Suppressor Barrel Kit.

The ZiP™ System once again showcases the modularity and open upgrade architecture for the New ZiP-22!

Includes Special ZiP-Action Rod for total clearance near rear of suppressor. Suppressor in "direct thread on mode" will seat at bottom of 1/2x28.

What's in the Kit?

(1) ZiP Suppressor 4140, Machined Barrel, Length 5.25 inches

(1) ZiP Suppressor Barrel Nut, Midnite Blackout and Knurled, with 1/2x28 thread.

(1) ZiP Action Rod-(Re-strike) Length to fit the install length of suppressor.

(1) Screw for Short Action rod.

 

ZiPOperator™ Recoil Spring –For Suppressed Fire:  Use “High Velocity Springs” (identified by 3 dead coils on each end) in this suppressed condition. The additional back pressure will need to be counteracted by the heavier set of springs.

Follow instructions in ZiP™ Manual for simple barrel swap out.

ZiP Factory Store did recieve in this kit: Anticipated "Live on AMAZON" is Mid May 2013